Removal Procedure
- Remove the quarter inner rear trim finishing panel.
- Remove the spare tire and jack.
- Disconnect the antenna
cable (4) from the power antenna.
- Disconnect the power antenna electrical connector (3).
- Remove the drain tube (1) from the grommet in the rear quarter
panel.
- Remove the power antenna bracket bolt (2).
- Pull down the bracket. Disengage the power antenna from the antenna
bezel.
- Remove the power antenna.
- Unsnap the bezel from the rear quarter panel.
- Remove the antenna bezel.
Installation Procedure
- Snap the bezel into the
rear quarter panel in order to install the antenna bezel.
Notice: Refer to Fastener Notice in the Preface section.
- Install the power antenna.
- Install the power antenna bracket bolt (2).
Tighten
Tighten the power antenna bracket bolt to 5 N·m (44 lb in).
- Install the drain tube (1) to the grommet in the rear quarter
panel.
- Connect the power antenna electrical connector (3).
- Connect the antenna cable (4) to the power antenna.
- Install the jack and the spare tire.
- Install the quarter inner rear trim finishing panel.