GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2001 🢒 Safari - 4WD 🢒 Body and Accessories 🢒 Body Front End 🢒 Front Fender Replacement

Removal Procedure
  1. Remove the bumper. Refer to Front Bumper Impact Bar Replacement .
  2. Raise and support the hood.
  3. Remove the screws retaining the windshield frame filler panel.
  4. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .

    5. Object Number: 321597 Size: SH
  5. Remove the hood to fender nut and bolt.
  6. Remove the front rocker panel cladding. Refer to Cladding Replacement - Rocker Panel in Exterior Trim.
  7. Remove the front wheel house extension. Refer to Wheelhouse Extension Replacement .
  8. Remove the fender to the body bolts.

    9. Object Number: 321591 Size: SH
  9. Remove the fender from the body.

Installation Procedure
  1. Install the fender to the body.

    2. Object Number: 321597 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the fender to the body bolts.

    3. Tighten
    Tighten the fender to the body bolts to 13 N·m (115 lb in).

  3. Install the front wheel house extension. Refer to Wheelhouse Extension Replacement .
  4. Install the front rocker cladding. Refer to Cladding Replacement - Rocker Panel in Exterior Trim.

    5. Object Number: 321591 Size: SH
  5. Install the hood to fender nut and bolt.

    6. Tighten
    Tighten the hood to fender nut and bolts to 13 N·m (115 lb in).

  6. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
  7. Install the screws retaining the windshield frame filler panel.

    8. Tighten
    Tighten the screws retaining the windshield frame filler panel to 2 N·m (18 lb in).

  8. Install the bumper. Refer to Front Bumper Impact Bar Replacement .
  9. Close the hood.