Removal Procedure
- Use a grease pencil in order to mark the position of the bracket
on the door.
- Disconnect the lower corner of the door trim panel to expose the
bracket (2) to door bolts.
- Support the bottom of the door.
- Remove the bracket (2) to door bolts.
- Slide the bracket (2)
out of the rear of the track in order to remove the bracket from the body.
Installation Procedure
- Slide the bracket rollers (2) into the rear of the track
in order to install the bracket to the body.
- Align the bracket with
the marks made during removal in order to install the bracket to the door.
Notice: Refer to Fastener Notice in the Preface section.
- Install the bolts that retain the bracket to the door.
Tighten
Tighten the bracket retaining bolts to 25 N·m (18 lb ft).
- Remove the support from the bottom of the door.
- Install the lower corner of the door trim panel by pressing into
place until fully seated.