GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the trim panel. Refer to Rear Door Trim Panel Replacement .
  2. Separate the weatherstrip deflector at the perforation. Use a sharp-bladed tool if needed. Refer to Water Deflector Replacement .

  3. Object Number: 324255  Size: SH
  4. Remove the control rod from the lock assembly.

  5. Object Number: 324256  Size: SH
  6. Remove the bolts and the reinforcement.

  7. Object Number: 324257  Size: SH
  8. Remove the following components from the door:
  9. • The latch
    • The rod
    • The retainer
  10. Remove the rod and the retainer from the latch.

Installation Procedure


    Object Number: 324257  Size: SH
  1. Install the control rod and the retainer to the latch.
  2. Install the retainer as shown in order to prevent squeaks and rattles.
  3. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 324256  Size: SH
  4. Install the following components to the door. Ensure that the arrow on the retainer points toward the front of the vehicle:
  5. • The latch
    • The retainer
    • The bolts

    Tighten
    Tighten the bolts to the door to 8 N·m (71 lb in).


    Object Number: 324255  Size: SH

    Important: Install new nylon retainers whenever you remove the control rods.

  6. Install the control rod to the lock assembly.
  7. Install the water deflector. Refer to Water Deflector Replacement .
  8. Install the trim panel. Refer to Rear Door Trim Panel Replacement .