For 1990-2009 cars only
Removal Procedure
- Remove the IP extension. Refer to Instrument Panel Extension Replacement in Instrument Panel, Gages, and Console.
- Remove the floor air outlet duct from the air distributor.
- Remove the bucket seats. Refer to Bucket Seat Replacement in Seats.
- Remove the front section of the carpet, if equipped. Refer to Front Floor Mat/Carpet Replacement in Interior Trim.
- Remove the retaining nuts from the floor outlet duct, if equipped.
- Remove the floor air outlet from the ducts to the rear seat, if equipped.
Installation Procedure
- Install the floor air outlet to the ducts to the rear seat, if equipped.
- Install the retaining nuts to the floor outlet duct, if equipped.
- Install the front section of the carpet, if equipped. Refer to Front Floor Mat/Carpet Replacement in Interior Trim.
- Install the bucket seats. Refer to Bucket Seat Replacement in Seats.
- Install the floor air outlet duct from the air distributor.
- Install the IP extension. Refer to Instrument Panel Extension Replacement in Instrument Panel, Gages, and Console.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the nuts to 2 N·m (18 lb in).
