Tools Required

J 23523-F Crankshaft Balancer Puller and Installer

1. Open the hood.

Caution: Before servicing any electrical component, the ignition and start switch must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.

2. Disconnect the battery negative cable from the battery. Refer to Battery Cable Replacement in Engine Electrical.



3. Remove the upper fan shroud from the radiator.
4. Remove the drive belt from the vehicle. Refer to Drive Belt Replacement .
5. Raise the vehicle and support with safety stands. Refer to Lifting and Jacking the Vehicle . Vehicle Lifting and Jacking in General Information.



6. Remove the lower fan shroud from the radiator.
7. Remove the fan clutch from the water pump. Refer to Fan Clutch Replacement .



8. Remove the drive belt pulley from the balancer.



9. Remove the crankshaft balancer (external) bolt.



10. Use the J 23523-F to remove the crankshaft balancer.
11. Remove the crankshaft key, if necessary.

Important: The inertial weight section of the crankshaft balancer is assembled to the hub with a rubber-type material. The correct installation procedures (with the proper tool) must be followed or movement of the inertial weight section of the hub will destroy the balancer and will have to be replaced.

Tools Required

J 23523-F Crankshaft Balancer Puller and Installer

1. Install the crankshaft balancer key, if removed.
2. Apply a small amount of clean engine oil on the sealing surface of the new crankshaft balancer.



3. Install the J 23523-F stud to the crankshaft. Thread the stud fully into the tapped hole in the crankshaft.
4. Install the crankshaft balancer (external) over the end of the crankshaft.
5. Align the keyway in the crankshaft balancer with the crankshaft key.
6. Use a small amount of RTV sealer GM P/N 12345739 or equivalent to seal the crankshaft key to the crankshaft.
7. Install the bearing, washer, and nut.
8. Turn the nut to pull the crankshaft balancer into place and remove J 23523-F .




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

9. Install the crankshaft balancer bolt and washer.

Tighten
Tighten the crankshaft balancer bolt to 149 N·m (110 lb ft).




10. Install the drive belt pulley on the crankshaft.

Tighten
Tighten the bolts to 40 N·m (30 lb ft).




11. Install the fan clutch to the water pump. Refer to Fan Clutch Replacement . Engine Cooling Fan Replacement in Engine Cooling.



12. Install the lower fan shroud to the radiator.
13. Remove the safety stands and lower the vehicle. Refer to Lifting and Jacking the Vehicle . Vehicle Lifting and Jacking in General Information.
14. Install the drive belt in the vehicle. Refer to Drive Belt Replacement .



15. Install the upper fan shroud to the radiator.
16. Connect the battery negative cable to the battery. Refer to Battery Cable Replacement .
17. Close the hood.