GM Service Manual Online
For 1990-2009 cars only

Temperature Valve Assembly Inoperative - Auxiliary Cargo Van

Step

Action

Value(s)

Yes

No

1

Was the HVAC Air Delivery System Check performed?

--

Go to Step 2

Go to HVAC Air Delivery System Check

2

  1. Place the ignition switch in the RUN position.
  2. Disconnect the connector at the rear auxiliary temperature valve assembly.
  3. Connect an unpowered test lamp between the rear auxiliary temperature valve assembly connector, cavity 10 for CKT 341 (BRN), and ground.

Does the test lamp light?

--

Go to Step 3

Go to Step 8

3

Connect a J 39200 between the rear auxiliary temperature valve assembly connector, cavity 7 for CKT 150 (BLK), and ground.

Does the circuit have continuity?

--

Go to Step 4

Go to Step 9

4

  1. Place the front auxiliary HVAC control module blower motor switch in the OFF position.
  2. Connect a J 39200 between the rear auxiliary temperature valve assembly connector, cavity 8 for CKT 734 (DK GRN), and ground.
  3. Monitor the voltmeter while adjusting the temperature control knob at the front auxiliary HVAC control module.

Is voltage indicated and does the voltage vary?

--

Go to Step 10

Go to Step 5

5

  1. Disconnect the front auxiliary HVAC control module connector.
  2. Connect an unpowered test lamp between the front auxiliary HVAC control module connector, cavity H for CKT 734 (DK GRN), and ground.

Does the test lamp light?

--

Go to Step 11

Go to Step 6

6

Connect a J 39200 between the front auxiliary HVAC control module connector, cavity B for CKT 734, and ground.

Does the ciruit have continuity?

--

Go to Step 12

Go to Step 7

7

  1. Connect a fused jumper wire between the rear auxiliary temperature valve connector, cavity 8 for CKT 734 (DK GRN), and ground.
  2. Connect a J 39200 between the front auxiliary HVAC control module connector, cavity H for CKT 734 (DK GRN), and ground.

Does the circuit have continuity?

--

Go to Step 13

Go to Step 14

8

Repair the open in CKT 341 (BRN) between splice S405 and the rear auxiliary temperature valve assembly.

Refer to Wiring Repairs .

Is the repair complete?

--

Go to HVAC Air Delivery System Check

--

9

Repair the open in CKT 150 (BLK) between the rear auxiliary temperature valve and splice S411.

Refer to Wiring Repairs .

Is the repair complete?

--

Go to HVAC Air Delivery System Check

--

10

Replace the rear auxiliary temperature valve assembly.

Refer to Mode Door Actuator Replacement - Auxiliary .

Does the rear the auxiliary temperature valve operate?

--

Go to HVAC Air Delivery System Check

--

11

Repair the short to voltage in CKT 734 (DK GRN) between the front auxiliary HVAC control module and the rear auxiliary temperature valve assembly.

Refer to Wiring Repairs .

Is the repair complete?

--

Go to HVAC Air Delivery System Check

--

12

Repair the short to ground in CKT 734 (DK GRN) between the front auxiliary HVAC control module and the rear auxiliary temperature valve assembly.

Refer to Wiring Repairs .

Is the repair complete?

--

Go to HVAC Air Delivery System Check

--

13

Replace the front auxiliary HVAC control module.

Refer to Control Switch Replacement - Auxiliary .

Is the repair complete?

--

Go to HVAC Air Delivery System Check

--

14

Repair the open in CKT 734 (DK GRN) between the front auxiliary HVAC control module and the rear auxiliary temperature valve assembly.

Refer to Wiring Repairs .

Is the repair complete?

--

Go to HVAC Air Delivery System Check

--

Temperature Valve Assembly Inoperative - Auxiliary Passenger Van

Step

Action

Value(s)

Yes

No

1

Was the HVAC Air Delivery System Check performed?

--

Go to Step 2

Go to HVAC Air Delivery System Check

2

  1. Place the ignition switch in the RUN position.
  2. Disconnect the rear auxiliary temperature valve assembly connector.
  3. Connect an unpowered test lamp between the rear auxiliary temperature valve assembly connector, cavity 10 for CKT 341 (BRN), and ground.

Does the test lamp light?

--

Go to Step 3

Go to Step 8

3

Connect a J 39200 between the rear auxiliary temperature valve assembly connector, cavity 7 for CKT 150 (BLK), and ground.

Does the circuit have continuity?

--

Go to Step 4

Go to Step 9

4

  1. Place the front auxiliary HVAC control module blower motor switch in the OFF position.
  2. Connect a J 39200 between the rear auxiliary temperature valve assembly connector, cavity 8 for CKT 734 (DK GRN), and ground.
  3. Monitor the voltmeter while adjusting the temperature control knob at the front auxiliary HVAC control module.

Is voltage indicated and does the voltage vary?

--

Go to Step 10

Go to Step 5

5

  1. Disconnect the heater and A/C control logic module connector.
  2. Connect an unpowered test lamp between the heater and A/C control logic module connector, cavity B for CKT 734 (DK GRN), and ground.

Does the test lamp light?

--

Go to Step 11

Go to Step 6

6

Connect a J 39200 between the heater and A/C control logic module connector, cavity B for CKT 734, and ground.

Does the circuit have continuity?

--

Go to Step 12

Go to Step 7

7

  1. Connect a fused jumper wire between the rear auxiliary temperature valve connector, cavity 8 for CKT 734 (DK GRN), and ground.
  2. Connect a J 39200 between the heater and A/C control logic module connector, cavity B for CKT 734 (DK GRN), and ground.

Does the circuit have continuity?

--

Go to Step 13

Go to Step 14

8

Repair the open in CKT 341 (BRN) between splice S405 and the rear auxiliary temperature valve assembly.

Refer to Wiring Repairs .

Is the repair complete?

--

Go to HVAC Air Delivery System Check

--

9

Repair the open in CKT 150 (BLK) between the rear auxiliary temperature valve and splice S411.

Refer to Wiring Repairs .

Is the repair complete?

--

Go to HVAC Air Delivery System Check

--

10

Replace the rear auxiliary temperature valve assembly.

Refer to Mode Door Actuator Replacement - Auxiliary .

Is the repair complete?

--

Go to HVAC Air Delivery System Check

--

11

Repair the short to voltage in CKT 734 (DK GRN) between the heater and A/C control logic module and the rear auxiliary temperature valve assembly.

Refer to Wiring Repairs .

Is the repair complete?

--

Go to HVAC Air Delivery System Check

--

12

Repair the short to ground in CKT 734 (DK GRN) between the heater and A/C control logic module and the rear auxiliary temperature valve assembly.

Refer to Wiring Repairs .

Is the repair complete?

--

Go to HVAC Air Delivery System Check

--

13

Replace the heater and A/C control logic module.

Is the repair complete?

--

Go to HVAC Air Delivery System Check

--

14

Repair the open in CKT 734 (DK GRN) between the heater and A/C control logic module and the rear auxiliary temperature valve assembly.

Refer to Wiring Repairs .

Is the repair complete?

--

Go to HVAC Air Delivery System Check

--