Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Was the Wiper/Washer System Check performed? | -- | Go to Step 2 | |
2 |
Did the test lamp light? | -- | Go to Step 4 | Go to Step 3 |
3 | Repair the open in CKT 143 (YEL) between splice S134 and the windshield wiper motor. Do the wipers still operate in high speed only? | -- | Go to Step 4 | |
4 |
Is continuity present? | -- | Go to Step 5 | Go to Step 6 |
5 | Repair the short to ground in CKT 96 (BRN) between connector C200 and the windshield wiper motor. Do the wipers still operate in high speed only? | -- | Go to Step 6 | |
6 |
Is continuity present? | -- | Go to Step 7 | Go to Step 8 |
7 | Inspect for an open in CKT 96 (BRN) between connector C200 pin E5 and the windshield wiper motor connector cavity D. Was an open detected? | -- | Go to Step 9 | Go to Step 10 |
8 |
Do the wipers still operate in high speed only? | -- | -- | |
9 | Repair the open. open in CKT 96 (BRN) between connector C200 pin E5 and the windshield wiper motor connector cavity D. Is the repair complete? | -- | Go to Step 10 | |
10 | Replace the multifunction lever. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle in Steering Wheel and Column - Standard or Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle in Steering Wheel and Column - Tilt. Is the repair complete? | -- | -- |
