Circuit Description
The fuel manager/filter assembly consists of the fuel heater, the water-in-fuel sensor and a filter. The filter contains the coalescer (the device that combines small droplets of water into larger ones) and the filter/separator.
A fuel lift pump delivers diesel fuel from the tank to the fuel filter. As fuel enters the filter, the fuel passes first though the fuel heater. The heater contains a thermostatic switch, which opens or closes to turn the heater OFF or ON, depending on the temperature of the fuel.
The fuel then passes through the filter and the water coalescer, where the droplets of water in the fuel combine into larger drops, that fall into the water reservoir in the filter. When fuel flows from the fuel manager/filter assembly to the injection pump, the fuel is clean and free of water.
The solid state water-in-fuel sensor supplies voltage to a probe. When the probe touches water, the module closes a switch. This completes a circuit to ground and lights the water-In-fuel lamp.
A circuit in the water-in-fuel module grounds the lamp briefly to test the bulb each time the system is turned ON.
Test Description
Number(s) below refer to step number(s) on the Diagnostic Table.
-
This step will determine if the ignition feed circuit is open.
-
This step will determine if the ground circuit is OK.
-
This step will determine if the fuse, bulb, and wiring are OK.
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Turn the ignition ON leaving the engine OFF. Does the water In fuel light come ON briefly? | -- | ||
Is the test light ON? | -- | |||
With an J 35616-200 unpowered test lamp, jumper the harness terminals A and C with the ignition still ON. Is the test light ON? | -- | |||
With an J 35616-200 unpowered test lamp connected to ground, probe terminal B of the harness connector. Is the test light ON? | -- | |||
5 | Operate the vehicle under which the system was noted. Does the system operate properly? | -- | System OK | |
6 |
Did you perform a repair? | -- | ||
7 |
Did you perform a repair? | -- | ||
8 |
Did you perform a repair? | -- | ||
9 |
Did you perform a repair? | -- | ||
10 | Repair the open in the lamp circuit. Is the action complete? | -- | -- | |
11 | Replace the Water In Fuel sensor. Refer to Water in Fuel Indicator Sensor Replacement . Is the action complete? | -- | -- | |
12 | Operate the vehicle under which the original problem was noted. Does the system operate properly? | -- | System OK |
