- Remove the turn signal cancel cam, bearing thrust washer. Refer
to
Turn Signal Cancel Cam and Bearing Thrust Washer - Disassemble - Off Vehicle
.
- Remove the park lock cable
assembly (1) from the electronic lock module assembly.
2.1. | Place the lock cylinder in the OFF-LOCK position. |
2.2. | Place the shift lever clevis into the PARK position. |
2.3. | Insert a small screwdriver into the slot on the electronic lock
module assembly. Push against the locking tab on the end of the park lock
cable assembly (1). |
2.4. | Disconnect the park lock cable assembly (1) from the electronic
lock module assembly. |
- Rotate the key alarm connector (1)
90 degrees.
- Pull the key alarm connector (1) out of the electronic
lock module assembly (2).
- Remove the 2 tapping screws from the ignition and key alarm
switch assembly (3).
- Remove the ignition and key alarm switch assembly (3) from
the electronic lock module assembly (2).
- Let the ignition and key alarm switch assembly (3) hang
freely.
- Remove the 3 pan
head tapping screws (2) from the electronic lock module assembly (1).
- Remove the electronic lock module assembly (1) from the
steering column housing assembly.