Tools Required

J 41396 Park Lock Cable Pliers

1. Install the electronic lock module assembly (1) onto the steering column housing assembly.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Screw the 3 pan head tapping screws (2) into the electronic lock module assembly.

Tighten
Tighten the pan head tapping screws to 7 N·m (62 lb in).




3. Install the ignition and key alarm switch assembly (1) onto the electronic lock module assembly (2).
4. Screw the 2 tapping screws into the ignition and key alarm switch assembly (1).

Tighten
Tighten the tapping screws to 1.5 N·m (13 lb in).

5. Install the key alarm connector (3) onto the electronic lock module assembly (2).

4.1.	Push the key alarm connector (1) into the electronic lock module assembly (2).

4.2.	Rotate the key alarm connector 90 degrees so that the key alarm connector locks into place.




6. Connect the park lock cable assembly (1).

•	Place the lock cylinder in the OFF-LOCK position.

•	Place the gear shift lever clevis into the PARK position.

•	Press the locking tab on the end of the park lock cable assembly (1) into the slot in the electronic lock module assembly.

7. Install the upper steering column housing components. Refer to Turn Signal Cancel Cam and Bearing Thrust Washer - Assemble - Off Vehicle .