Evaporative Emission Canister Replacement Passenger/Cargo Van

Caution: To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to the hoist.




1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the evaporative emission (EVAP) canister retainer (2).



3. Disconnect the vent hose (2) from the canister.



4. Disconnect the chassis EVAP purge pipe (5) from the EVAP canister.
5. Disconnect the fuel tank EVAP pipe (1) from the canister.
6. Remove the EVAP canister from the fuel tank shield.

1. Install the EVAP canister to the fuel tank shield.
2. Connect the fuel tank EVAP pipe (1) to the canister.
3. Connect the chassis EVAP purge pipe (5) to the EVAP canister.



4. Connect the vent hose (2) to the canister.



5. Install the EVAP canister retainer (2).
6. Lower the vehicle.

Evaporative Emission Canister Replacement Cutaway Van

Caution: To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to the hoist.




1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the evaporative emission (EVAP) canister bracket bolt (2).



3. Disconnect the vent hose (2) from the canister.



4. Disconnect the chassis EVAP purge pipe (5) from the EVAP canister.
5. Disconnect the fuel tank EVAP pipe (1) from the canister.



6. Remove the EVAP canister from the bracket.

1. Connect the fuel tank EVAP pipe (1) to the canister.
2. Connect the chassis EVAP purge pipe (5) to the EVAP canister.



3. Connect the vent hose (2) to the canister.



4. Install the EVAP canister to the bracket.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Install the EVAP canister bracket bolt (2).

Tighten
Tighten the EVAP canister bracket bolt to 12 N·m (106 lb in).

6. Lower the vehicle.