Data Link Connector Diagnosis. GMC Truck Savana 2000

For 1990-2009 cars only

Makes 🢒 GMC_Truck 🢒 2000 🢒 Savana 🢒 Engine 🢒 Engine Controls - 6.5L (L65) 🢒 Data Link Connector Diagnosis

Engine Controls Components
Fuses, MIL, PCM, DLC, G101, G103, G201
OBD II Symbol Description Notice
Handling ESD Sensitive Parts Notice
Handling ESD Sensitive Parts Notice

Circuit Description

There should always be a steady Malfunction Indicator Lamp (MIL) when the ignition is ON and the engine is OFF. Battery ignition voltage is supplied to the lamp. The PCM will turn the lamp ON by grounding the MIL control circuit.

Test Description

The numbers below refer to the step numbers on the diagnostic table.

This step verifies if the problem is in the scan tool or the vehicle.

If the resistance reading is below 10 ohms, this indicates that the Serial Data circuit or a Controller Module that shares the circuit is shorted to ground or shorted internally.

By disconnecting each controller module that shares the Serial Data circuit and re-checking the resistance can determine if a shared controller module is shorted internally.

This step checks the Serial Data circuit for a short to voltage.

A resistance reading under 10 ohms indicates that the circuit has continuity. A high resistance reading indicates an open in the circuit.

Step

Action

Value(s)

Yes

Did you perform the Powertrain On-Board Diagnostic (OBD) System Check?

Go to Step 2

Go to Powertrain On Board Diagnostic (OBD) System Check

Disconnect the scan tool from the vehicle.
Connect the scan tool to a vehicle with the same model year and with the same systems.
Turn ON the ignition, with the engine OFF.

Does the PCM communicate with the scan tool?

Go to Step 3

Go to Step 4

Reconnect the scan tool to the original vehicle.
Turn ON the ignition, with the engine OFF.

Does the scan tool communicate with the PCM?

Go to Step 11

Go to Step 5

The scan tool may be malfunctioning. Refer to the scan tool instruction manual.

Is the action complete?

Go to Step 17

Turn OFF the ignition.
Disconnect the PCM connectors.
With a J 39200 DMM , measure the resistance at the DLC connector between terminal 4 and terminal 2.

Is the resistance less than the specified value?

10 ohms

Go to Step 6

Go to Step 7

Disconnect the electronic brake control module (EBCM).
Measure the resistance at the DLC connector between terminal 4 and terminal 2.
Repeat the procedure for the following shared Modules on the Serial Data circuit.

•	Power Steering Control Module

•	EVO Module

•	Automatic transfer case (ATC) Module (if equipped)

Does disconnecting one of the Modules cause the resistance to be more than the specified value?

10 ohms

Go to Step 15

Go to Step 14

Turn ON the ignition, with the engine OFF.
With the J 39200 DMM, measure the voltage at the DLC connector between terminal 4 and terminal 2.

Is the voltage less than the specified value?

1.0 V

Go to Step 8

Go to Step 12

Turn OFF the ignition.
With the DMM, measure the resistance between the DLC connector terminal 2 and the Serial Data circuit terminal at the PCM connector.

Is the resistance less than the specified value?

10 ohms

Go to Step 9

Go to Step 13