Notice

Do not raise the engine block by the crankshaft balancer to perform this service procedure. Damage to the crankshaft balancer or the crankshaft may occur.

1. Disconnect the battery negative cable from the battery. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
2. Remove the engine cover from the vehicle. Refer to Engine Cover Replacement in Interior Trim.
3. Raise the vehicle and support with safety stands. Refer to Lifting and Jacking the Vehicle in General Information.
4. Remove the oil pan from the vehicle. Refer to Oil Pan Replacement
5. Remove the oil pump mounting bolts.
6. Remove the oil pump assembly from the crankshaft rear bearing cap.

Important: When servicing the oil pump assembly, always replace the retainer between the oil pump hex drive and the oil pump.

1. Prime the oil pump assembly.

1.1.	Submerge the oil pump in a container with clean motor oil.

1.2.	Rotate the oil pump hex drive by hand until the oil begins to flow from the oil pump assembly.

1.3.	Clean the excess motor oil from the outside of the oil pump assembly.

2. Install a new retainer between the oil pump and the hex drive shaft.
3. Align the extension shaft with the drive shaft to the oil pump drive gear. the oil pump should slide easily into place, do not force the oil pump into place.
4. Install the oil pump and the extension shaft to the crankshaft rear bearing cap.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Install the oil pump mounting bolts to the oil pump.

Tighten
Tighten the bolts to 90 N·m (65 lb ft).

6. Install the oil pan to the engine block. Refer to Oil Pan Replacement .
7. Remove the safety stands and lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
8. Connect the battery negative cables to the batteries. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
9. Install the engine cover in the vehicle. Refer to Engine Cover Replacement in Interior Trim.