For 1990-2009 cars only
Removal Procedure
- Remove the transmission fluid level indicator from the fluid fill tube.
- Remove the bolt securing the transmission fluid fill tube bracket to the engine.
- Remove the bolt securing the transmission fluid fill tube bracket to the transmission.
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove any dirt from the transmission where the fluid fill tube enters the transmission case.
- Remove the transmission fluid fill tube from the transmission. Pull the tube upward from the transmission.
- Remove the transmission fill tube seal.
- Clean the metal parts using solvent. Do not allow the solvent to enter the transmission.
- Air dry the parts.
Installation Procedure
- Install a new oil level indicator tube seal into the transmission case.
- Install the oil level indicator tube into the seal.
- Install the bolt securing the oil level indicator tube bracket to the transmission.
- Install the bolt securing the oil level indicator tube bracket to the engine.
- Lower the vehicle.
- Install the oil level indicator.
- Check the transmission fluid level. Refer to Fluid Capacity Specifications and to Transmission Fluid Check .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolt to 6 N·m (53 lb in).
Tighten
Tighten the bolt to 6 N·m (53 lb in).
