Important: Do not try to disassemble the linear EGR valve. Service the EGR valve only as a complete assembly.

Important: Carefully note the position of the linear EGR valve before removal. Do not rotate the linear EGR valve 180 degrees.

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Disconnect the negative battery cable.
2. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .



3. Remove the linear EGR harness connector.
4. Remove the bolts attaching the linear EGR valve to the flange .




Notice: The Linear EGR valve is an electrical component. DO NOT soak in any liquid cleaner or solvent because damage may result.

5. Remove the linear EGR valve.
6. Remove the flange gasket.
7. Clean the EGR valve gasket surface.

1. Install the new flange gasket
2. Install the linear EGR valve.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the bolts retaining the linear EGR valve to the flange .

Tighten

1. Tighten the bolts the first time to 10 N·m (89 lb in).
2. Tighten the bolts a final time to 25 N·m (18 lb ft).



4. Install the EGR valve harness connector.
5. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
6. Connect the negative battery cable.