DEFINITION: The fasten safety belt chime sounds with the driver's seat belt buckled.

Did you review the audible warning circuit description and perform the necessary inspections?

--

Go to Step 2

Go to Symptoms - Audible Warnings

1. Unbuckle the driver's seat belt.
2. Turn the ignition switch to RUN.
3. Buckle the driver's seat belt.

Does the fasten safety belt chime sound only until the driver's seat belt is buckled?

--

Go to Testing for Intermittent Conditions and Poor Connections

Go to Step 3

Important: Refer to Disabling the SIR System in SIR before disconnecting the inflatable restraint sensing and diagnostic module.

1. Turn the ignition switch OFF.
2. Disconnect multi-function alarm module connector C1.
3. Disconnect the seat belt switch.
4. Disconnect the inflatable restraint sensing and diagnostic module.
5. Connect a J 39200 DMM between multifunction alarm module connector C1 cavity A2 for CKT 238 (BLK/WHT) and ground. Refer to Circuit Testing in Wiring Systems.

Is continuity present?

--

Go to Step 5

Go to Step 4

1. Fasten the driver's side safety belt.
2. Connect a J 39200 DMM between seat belt switch pigtail pin A and pigtail pin B. Refer to Circuit Testing in Wiring Systems.

Is continuity present?

--

Go to Step 6

Go to Step 7

Repair the short to ground between the multi-function alarm module and either the seat belt switch or the inflatable restraint sensing and diagnostic module. Refer to Wiring Repairs in Wiring Systems.

Is the repair complete?

--

Go to Step 8

Go to Step 3

Replace the seat belt switch. Refer to Front Seat Belt Buckle Replacement in Seat Belts.

Is the repair complete?

--

Go to Step 8

Go to Step 3

Replace the multi-function alarm module. Refer to Multifunction Alarm Module Replacement .

Is the repair complete?

--

Go to Step 8

Go to Step 3

Operate the system in order to verify the repair.

Did you correct the condition?

--

System OK

Go to Step 3