Transmitter Programming Domestic

1. Ground pin 4 to pin 8 of the data link connector.
2. Press and hold the LOCK and UNLOCK buttons simultaneously, on the first transmitter to be programmed until the locks cycle (approximately 10 seconds).

The receiver will respond by locking/unlocking all of the doors.

3. Press any button on the next transmitter to be programmed.

•	The receiver will respond by locking/unlocking all of the doors.

•	Repeat step 3 for all the transmitters that are to be programmed (up to 4 transmitters can be programmed).

•	Do not wait more than 1 minute between programming the transmitters or the receiver will require holding the lock/unlock buttons for 15 seconds instead of 2 seconds.

4. Remove the ground applied from pin 4 to pin 8 of the DLC.
5. The transmitter operation is verified by locking and unlocking the doors.

Transmitter Programming Export

The capability to program a key fob into the VIM is provided in case of a lost or broken key fob. An additional key fob is needed if the VIM is replaced. All the key fobs must be programmed into the VIM during this procedure. All stored fob codes are erased upon receipt of a valid code. In order to accomplish this procedure, refer to Override Procedure.

When the SECURITY lamp is ON steady for 10 seconds this indicates the override code has been accepted. Perform the following steps:

1. While the SECURITY lamp is ON, press either button on the key fob twice with at least 1 second between presses. The SECURITY lamp will flash 12 times in a 4 second period in order to acknowledge storing of the key fob fixed and variable code. Also that all formerly stored codes have been erased.
2. Step 1 may be repeated 3 more times for a total of 4 key fobs. If the VIM does not receive a key fob signal within 10 seconds after the correct override code has been entered, the immobilization function will be inactive for 2 minutes (enable fuel continue message to VCM) and the SECURITY lamp is turned OFF. If the ignition switch is turned OFF and then ON within the 2 minutes, the engine will start.
3. For further information, refer to Vehicle Theft Deterrent (VTD) Description .