GM Service Manual Online
For 1990-2009 cars only

Circuit Description

As the wheel spins, the wheel speed sensor produces an AC signal. The electronic brake control module (EBCM) uses the frequency of the AC signal to calculate the wheel speed.

Conditions for Running the DTC

    • Ignition switch in the RUN position.
    • All of the wheel speed sensor signals are above 32 km/h (20 mph) when the brake is applied or 19 km/h (12 mph when the brake is released.

Conditions for Setting the DTC

Either of the following conditions will set DTC C0229.

    • A sudden loss of both of the front wheel speed sensor signals is detected for 15 milliseconds.
    • A sudden increase is detected in both of the front wheel speed sensor signals at a rate greater than 8.8 km/h (5.5 mph) for 105 milliseconds.

Action Taken When the DTC Sets

    • The ABS and BRAKE indicators are commanded on.
    • The ABS is disabled for the remainder of the ignition cycle.

Conditions for Clearing the DTC

    • Repair the condition(s) responsible for setting the DTC.
    • Use a scan tool in order to clear the DTC.

Diagnostic Aids

Thoroughly inspect connections or circuitry that may cause an intermittent malfunction. Refer to Testing for Intermittent Conditions and Poor Connections , Wiring Repairs , and Connector Repairs in Wiring Systems.

Step

Action

Value(s)

Yes

No

Schematic References: Antilock Brake System Schematics

1

Did you perform the ABS Diagnostic System Check?

--

Go to Step 2

Go to Diagnostic System Check

2

  1. Use the scan tool in order to clear the DTC(s).
  2. Operate the vehicle under the conditions for running the DTC as specified in the supporting text.

Does the DTC set?

--

Go to Step 3

Go to Diagnostic Aids

3

Inspect for poor connections at the harness connector of the EBCM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in wiring systems.

Did you find and correct the condition?

--

Go to Step 5

Go to Step 4

4

Important: Perform the Tire Size Calibration Procedure.

Replace the EBCM. Refer to Electronic Brake Control Module Replacement .

Did you complete the replacement?

--

Go to Step 5

--

5

    • Use the scan tool in order to clear the DTC.
    • Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.

Does the DTC set?

--

Go to Step 3

--