Important: Before clearing the DTCs, use the scan tool Capture Info to save the Freeze Frame and Failure Records for reference. The data in the control module is deleted once the Clear Info function is used.

Did you perform the Powertrain On-Board Diagnostic (OBD) System Check?

--

Go to Step 2

Go to Powertrain On Board Diagnostic (OBD) System Check

Important: The new PCM must be programmed.

Replace the PCM. Refer to Powertrain Control Module Replacement/Programming .

Is the action complete?

--

Go to Step 3

--

1. Use a scan tool in order to clear the DTCs.
2. Start the engine.
3. Allow the engine to idle until the engine reaches the normal operating temperature.
4. Select DTC and the Specific DTC function.
5. Enter the DTC number that was set.
6. Operate the vehicle within the Conditions for Setting this DTC until the scan tool indicates the diagnostic Ran.

Does the scan tool indicate the diagnostic Passed?

--

Go to Step 4

Go to Step 2

Does the scan tool display any additional undiagnosed DTCs?

--

Go to the applicable DTC table

System OK