Circuit Description
In this mode, the Passlock™ Module will learn the current Passlock™ Sensor code value. The following list is the 2 Passlock™ learn procedures:
| • | A 10 minute procedure that requires a Techline terminal. |
| • | A 30 minute learn procedure that requires a scan tool in order to clear the codes. |
Conditions for Setting the DTC
| • | A new (never installed in a vehicle) Passlock™ Module has been installed and the ignition is turned to ON but is not rotated to crank. Once the ignition switch has been rotated to crank, the Passlock™ Module will learn the Passlock™ code. |
| • | The Passlock™ Module is in the learn mode but does not see a valid Passlock™ Sensor code because of a sensor or a wiring problem. |
Actions Taken When the DTC Sets
The vehicle will not run and the security telltale will be ON.
Conditions for Clearing the DTC
| • | The DTC will clear after an ignition cycle has occurred after the Passlock™ Module has learned a valid code. |
| • | Passlock™ Module history codes will be cleared after 100 ignition cycles with no current codes active. |
| • | Using a scan tool. |
Diagnostic Aids
| • | Prior to replacing a Passlock™ Module insure all the diagnostics have been completed. If the Passlock™ Module has been replaced with an existing system condition, the replacement Passlock™ Module will not learn a new voltage code (DTC B3031) until the original condition has been repaired. |
| • | Perform a visual inspection of the wiring and the connectors. |
| • | Inspect the Passlock™ Sensor harness for an intermittent or poor connections (including the in-line connector). Refer to Intermittents and Poor Connections. |
Test Description
The numbers below refer to the numbers on the diagnostic table:
-
The Passlock™ Module learns an analog voltage code when the ignition switch is turned to the crank position. If a Passlock™ Module is replaced and the ignition is turned to the ON position, DTC B3031 will set until the module sees a crank switch position or until the Passlock™ Sensor has latched.
-
Turning the ignition switch to crank will reset DTC B3031 in a new module.
-
If a condition exists in one of the following circuits, troubleshoot the appropriate DTC prior to diagnosing DTC B3031:
| • | CKT 812 |
| • | CKT 1836 |
| • | CKT 1057 |
Step | Action | Value(s) | Yes | No | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
1 | Did you perform the VTD Diagnostic System Check? | -- | Go to Step 2 | |||||||||||||
Has the Passlock™ Module recently been replaced? | -- | Go to Step 3 | Go to Step 4 | |||||||||||||
Turn the ignition switch to the crank position and back to the ON position. In the crank position, the Passlock™ module will receive an analog voltage code from the sensor. Is the operation complete? | -- | -- | ||||||||||||||
Is one or more of the DTCs set? | -- | Go to Step 5 | ||||||||||||||
5 | Replace the Passlock sensor in the electronic column lock module assembly. Use the appropriate procedure from the following list:
Is the repair complete? | -- | Go to Step 7 | Go to Step 6 | ||||||||||||
6 | Replace the Passlock™ Module. Refer to Theft Deterrent Module Replacement . Is the repair complete? | -- | Go to Step 7 | -- | ||||||||||||
7 |
Is the repair complete? | -- | -- |
