GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2001 🢒 Savana 🢒 Engine 🢒 Engine Controls - 8.1L 🢒 Fuel Tank Fuel Pump Module Replacement

Removal Procedure

    Object Number: 371000 Size: SH
  1. Remove the fuel sender assembly. Refer to Fuel Sender Assembly Replacement .
  2. Note the position of the fuel strainer (2) on the fuel sender.
  3. Support the fuel sender assembly with one hand and grasp the strainer with the other hand.
  4. Pull the strainer off the fuel sender. Discard the strainer after inspection.
  5. Inspect the strainer. Replace a contaminated strainer and clean the fuel tank.
  6. Disconnect the fuel pump electrical connector (5).
  7. Remove the electrical connector retaining clip (6) from the fuel level sensor.
  8. Disconnect the electrical connector (7) from the fuel level sensor under the fuel sender cover.
  9. Remove the retaining clip (4) from the fuel level sensor.
  10. Squeeze the locking tangs and remove the fuel level sensor (3).
  11. Remove the fuel pressure sensor (1).

Installation Procedure

    Object Number: 371000 Size: SH
  1. Install the fuel pressure sensor (1).
  2. Install the fuel level sensor (3).
  3. Install the retaining clip (4) to the fuel level sensor.
  4. Connect the electrical connector (7) to the fuel level sensor.
  5. Connect the electrical connector retaining clip (6).
  6. Connect the fuel pump electrical connector (5).

    7. Important: Always install a new fuel strainer when replacing the fuel tank fuel pump module.

  7. Install a new fuel strainer (2) in the same position as noted during disassembly. Push the strainer on the bottom of the fuel sender until the strainer is fully seated.
  8. Install the fuel sender assembly. Refer to Fuel Sender Assembly Replacement .