- Remove the upper and lower trim covers. Refer to
Trim Covers, Shift Lever Seal - Disassemble - Off Vehicle
.
- Remove the wire harness
assembly (1) from the wire harness strap (2).
- Remove and dispose of the small wire harness straps from the wire
harness assembly (1).
- Slide the 2 connectors (2)
of the turn signal and multifunction switch assembly out of the bulkhead connector (1).
- Remove the key alarm connector (1)
from the electronic lock module assembly (2).
5.1. | Rotate the key alarm connector (1) 90 degrees. |
5.2. | Pull the key alarm connector (1) out of the electronic
lock module assembly (2). |
- Remove the 2 tapping
screws (2) from the ignition and key alarm switch assembly (1).
- Remove the ignition and key alarm switch assembly (1) from
the electronic lock module assembly.