Important: If the in-line filter is plugged, the fuel tank should be inspected internally and cleaned if necessary.

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
2. Relieve the fuel system pressure. Refer to Fuel Pressure Relief .



3. Disconnect the fuel feed pipes (5) at the filter (4).
4. Remove the attaching hardware from the in-line fuel filter clamp.
5. Remove the clamp from the filter.

1. Remove the protective caps from the new filter.
2. Install the clamp to the filter.
3. Install the attaching hardware to the in-line filter clamp. Install the hardware in the same positions as on the old filter noting the direction of fuel flow arrow.



4. Connect the fuel feed pipes (5) to the filter (4) and tighten.
5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
6. Inspect for fuel leaks.

6.1.	Turn ON the ignition for 2 seconds.

6.2.	Turn OFF the ignition for 10 seconds.

6.3.	Turn ON the ignition.

6.4.	Inspect for fuel leaks.