GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 442561  Size: SH
  1. Remove the pins (1) that hold the weatherstrip to the upper door.
  2. Remove the weatherstrip (3) from the upper door.
  3. Clean the surface of the door with approved cleaning solvent.

Installation Procedure


    Object Number: 442561  Size: SH
  1. Remove peel-off liner from saturated foam.
  2. Spray 85 percent alcohol 15 percent water mixture per GM 9981293 on saturated foam patch.
  3. Locate the part by lining up the two pins (1) on the top of the weatherstrip with the holes in the door sheet metal.
  4. Insert the pocket over the door flange and push down the pins until they are fully seated and there are no gaps between the door and the weatherstrip (3).
  5. Insert the pin that is located on the pocket into the door sheet metal until it is fully seated and there is no gap between the door and the weatherstrip.
  6. Complete the installation by tucking the bottom inner edge of the weatherstrip (3) into the top door flange.