Schematic Reference: Instrument Cluster Schematics

Did you perform the Instrument Cluster Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Instrument Cluster

1. Install a scan tool.
2. Turn ON the ignition, with the engine OFF.
3. Compare the scan tool Ignition Voltage parameter in the SIR Data data list to the volt gage display.

Does the Ignition parameter match the volt gage display?

Go to Diagnostic System Check - Engine Electrical in Engine Electrical

Go to Step 3

Replace the IPC. Refer to Instrument Cluster Replacement .

Did you complete the replacement?

Go to Step 4

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2