The brake switch informs the EBCM when the brake is depressed. The brake switch is normally closed, supplying 12 volts to the EBCM when the brake is released. When the brake pedal is pressed, voltage on the TCC brake switch signal circuit is 0 volts.
Any of the following conditions may cause the DTC to run.
• | The vehicle accelerates from 0 km/h (0 mph) to a speed greater than 56 km/h (35 mph). |
• | The vehicle experiences an ABS event involving all hydraulic circuits. |
Any of the following conditions may cause the DTC to set.
• | Voltage on the TCC brake switch signal circuit is always low. |
• | Voltage on the TCC brake switch signal circuit is always high. |
The EBCM stores this information-only DTC for as long as the condition is present.
The Conditions for Setting the DTC are no longer present and you use the scan tool Clear DTCs function.
Thoroughly inspect connections or circuitry that may cause an intermittent malfunction. Refer to Testing for Intermittent Conditions and Poor Connections , Connector Repairs , Testing for Electrical Intermittents and to Wiring Repairs in Wiring Systems.
The numbers below refer to the step numbers on the diagnostic table.
Step | Action | Yes | No |
---|---|---|---|
Schematic Reference: Antilock Brake System Schematics Connector End View Reference: Antilock Brake System Connector End Views | |||
1 | Did you perform the ABS Diagnostic System Check? | Go to Step 2 | |
2 |
Does the scan tool display Off? | Go to Step 3 | Go to Step 5 |
3 |
Does the scan tool display On? | Go to Diagnostic Aids | Go to Step 4 |
Does the scan tool display On? | Go to Step 9 | Go to Step 7 | |
Does the scan tool display Off? | Go to Step 9 | Go to Step 6 | |
6 | Test the ignition 3 voltage circuit and the TCC brake switch signal circuit for an open or a short to ground. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 12 | Go to Step 8 |
7 | Test the TCC brake switch signal circuit for a short to voltage. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 12 | Go to Step 8 |
8 | Inspect for poor connections at the harness connector of the EBCM. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 12 | Go to Step 10 |
9 | Inspect for poor connections at the harness connector of the stop lamp switch. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 12 | Go to Step 11 |
10 |
Important: Following EBCM replacement, use the scan tool to perform the Tire Size Calibration procedure. Replace the EBCM. Refer to Electronic Brake Control Module Replacement . Did you complete the replacement? | Go to Step 12 | -- |
11 | Replace the stop lamp switch. Refer to Stop Lamp Switch Replacement in Lighting Systems. Did you complete the replacement? | Go to Step 12 | -- |
12 |
Does the DTC reset? | Go to Step 2 | System OK |