Removal Procedure
- Remove the upper quarter panel applique. Refer to
Back Body Opening Side Applique and Tail Lamp Replacement
in Body Rear End.
- Remove the nuts (2) that retain the tail lamp to the upper quarter panel.
- Remove the center high mounted stop lamp lens (2) from the center
high mounted stop lamp applique (1).
- Disconnect the bulb sockets from the tail lamp (3).
- Remove the bulbs from the sockets by turning the bulbs in a counterclockwise
direction.
Installation Procedure
- Install the bulbs into the sockets by turning the bulbs in a clockwise direction.
- Connect the bulb sockets into the tail lamp (3).
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the tail lamp retaining nuts (2) to the upper quarter panel.
Tighten
Tighten the nuts to 5 N·m (44 lb in).
- Install the upper quarter panel applique. Refer to
Back Body Opening Side Applique and Tail Lamp Replacement
in Body Rear End.