GM Service Manual Online
For 1990-2009 cars only

Step

Action

Yes

No

Schematic Reference: Exterior Lights Schematics

Connector End View Reference: Lighting Systems Connector End Views or Instrument Panel, Gages, and Console Connector End Views in Instrument Panel, Gages, and Console

1

Did you perform the Lighting Systems Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Lighting Systems

2

Verify that the turn signal lamps and/or indicators are always on or flashing.

Do the turn signal lamps operate normally?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

3

Are only the turn signal indicators in the instrument panel cluster (IPC) always on or flashing?

Go to Step 8

Go to Step 4

4

Are only the turn signal lamps on 1 side of the vehicle always on or flashing?

Go to Step 5

Go to Step 7

5

Inspect the affected bulb/socket for an internal short, poor terminal contact, or a shorted filament.

Was a problem found?

Go to Step 12

Go to Step 6

6

Test the following circuits of the affected lamps for a short to voltage. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

    • Left or right turn signal indicator lamp supply voltage
    • Left or right front turn signal lamp supply voltage
    • Left or right mirror turn signal lamp supply voltage
    • Left or right rear turn signal lamp supply voltage
    • Left or right rear stop/turn lamp supply voltage
    • Left or right DRL/turn supply voltage
    • Left or right turn signal switch signal

Did you find and correct the condition?

Go to Step 15

Go to Step 7

7

Disconnect the multifunction turn signal switch.

Do the affected turn signals and indicators still illuminate?

Go to Step 10

Go to Step 9

8

Inspect for poor connections at the IPC. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 15

Go to Step 11

9

Inspect for poor connections at the multifunction turn signal switch. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 15

Go to Step 13

10

Inspect for poor connections at the turn/hazard flasher. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 15

Go to Step 14

11

Important: Perform the set up procedure for the IPC.

Replace the IPC. Refer to Instrument Cluster Replacement in Instrument Panel, Gages, and Console.

Did you complete the repair?

Go to Step 15

--

12

Replace or repair the affected bulb/socket.

Did you complete the repair?

Go to Step 15

--

13

Replace the multifunction turn signal switch. Refer to Turn Signal Multifunction Switch Replacement in Steering Wheel and Column.

Did you complete the replacement?

Go to Step 15

--

14

Replace the hazard/turn flasher. Refer Hazard and Turn Signal Flasher Replacement .

Did you complete the replacement?

Go to Step 15

--

15

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3