Removal Procedure
- Remove the window regulator handle, if equipped. Refer to
Door Window Regulator Handle Replacement
.
- Remove the inside door handle bezel. Refer to
Front Side Door Inside Handle Bezel Replacement
.
- Remove the screws (2) that retain the front door trim plate (1)
to the door panel.
- Pull the bottom of the front door trim plate (1) out in order to
release the front door trim plate (1) retainers.
- Remove the front door trim plate from the front door trim panel.
- Disconnect the electrical connectors from the switches on the front door
trim plate, if equipped.
- Remove the front door trim plate (1) from the vehicle.
Installation Procedure
- Partially install the front door trim plate (1) to the front door trim
panel.
- Connect the electrical connectors to the switches, if equipped.
- Align the retainers on the front door trim plate (1) to the slots
in the front door trim panel
- Push towards the door panel to engage the front door trim plate (1)
retainers.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the screws (2).
Tighten
Tighten the screw that retains the front door trim plate to 1.9 N·m
(17 lb in)
- Install the inside door handle bezel. Refer to
Front Side Door Inside Handle Bezel Replacement
.
- Install the window regulator handle, if equipped. Refer to
Door Window Regulator Handle Replacement
.