The Remote Keyless Entry (RKE) transmitter functions will work up to 65 feet
(20 m) away.
There are other conditions which can affect the performance of the transmitter.
See
Remote Keyless Entry (RKE) System
.
[block ](Lock): Press to lock all doors.
If enabled
through the Driver Information Center (DIC), the parking lamps will flash once to
indicate locking has occurred. If enabled through the DIC, the horn will chirp when [block ]
is pressed again within five seconds of the previous press of the lock button. See
DIC Vehicle Customization
for additional
information.
(Unlock): Press to unlock the drivers door. If
is pressed again within five seconds, all remaining doors will unlock.
The interior lamps will come on and stay on for 20 seconds or until the ignition
is turned on. If enabled through the DIC, the parking lamps will flash twice to indicate
unlocking has occurred. See
DIC Vehicle Customization
for additional information.
(Cargo Door): Press to unlock only the cargo doors.
(Vehicle Locator/Panic Alarm): Press and release
to locate your vehicle. The turn signal lamps will flash and the horn will sound three
times.
Press and hold for more than two seconds to activate the
panic alarm. The turn signal lamps will flash and the horn will sound repeatedly for
30 seconds. The alarm will turn off when the ignition is moved to ON/RUN or
is pressed again. The ignition must be in LOCK/OFF for the panic alarm to work.
Matching Transmitter(s) to Your Vehicle
Each RKE transmitter is coded to prevent another transmitter from unlocking
your vehicle. If a transmitter is lost or stolen, a replacement can be purchased through
your dealer/retailer. All transmitters need to be re-coded to match the new transmitter.
The lost transmitter will no longer work after the new transmitters are re-coded.
Each vehicle can have a maximum of four transmitters matched to it. See "Relearn
Remote Key" under
DIC Operation and Displays
for instructions on how to match RKE transmitters to your vehicle.
Battery Replacement
Replace the battery if the REPLACE BATTERY IN REMOTE KEY message displays in
the DIC. See "REPLACE BATTERY IN REMOTE KEY" under
DIC Warnings and Messages
for additional information.
Notice: When replacing the battery, do not touch
any of the circuitry on the transmitter. Static from your body could damage the transmitter.
To replace the battery in the RKE transmitter:
- Separate the halves of the transmitter with a flat, thin object inserted
into the notch on the side of the transmitter.
- Remove the old battery. Do not use a metal object.
- Insert the new battery, positive side facing down. Replace with a CR2032
or equivalent battery.
- Put the transmitter back together tightly.