Removal Procedure
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing
any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to
the vehicle or its components.
- Disconnect the negative battery cable.
- Relieve the fuel system pressure. Refer to
Fuel Pressure Relief
.
- Drain the fuel tank. Refer to
Fuel Tank Draining
.
- Remove the fuel tank. Refer to
Fuel Tank Replacement
.
- Remove the fuel sender assembly. Refer to
Fuel Sender Assembly Replacement
.
- Note the position of the fuel strainer (2) on the fuel sender.
- Support the fuel sender assembly with one hand and grasp the strainer
with the other hand.
- Pull the strainer off the fuel sender. Discard the strainer after inspection.
- Inspect the strainer. Replace a contaminated strainer and clean the fuel
tank.
- Disconnect the fuel pump electrical connector (5).
- Remove the electrical connector retaining clip (6) from the fuel
level sensor .
- Disconnect the electrical connector (7) from the fuel level sensor
under the fuel sender cover.
- Remove the retaining clip (4) from the fuel level sensor .
- Squeeze the locking tangs and remove the fuel level sensor (3).
- Remove the fuel pressure sensor (1).
Installation Procedure
- Install the fuel pressure sensor (1).
- Install the fuel level sensor (3).
- Install the retaining clip (4) to the fuel level sensor .
- Connect the electrical connector (7) to the fuel level sensor .
- Connect the electrical connector retaining clip (6).
- Connect the fuel pump electrical connector (5).
Important: Always install a new fuel strainer when replacing the fuel tank fuel pump module.
- Install a new fuel strainer (2) in the same position as noted during
disassembly. Push the strainer on the bottom of the fuel sender until
the strainer is fully seated.
- Install the fuel sender assembly. Refer to
Fuel Sender Assembly Replacement
.
- Install the fuel tank. Refer to
Fuel Tank Replacement
.
- Refill the fuel tank.
- Tighten the fuel filler cap.
- Connect the negative battery cable.
- Inspect for leaks:
13.1. | Turn ON the ignition for 2 seconds. |
13.2. | Turn OFF the ignition for 10 seconds. |
13.3. | Turn ON the ignition. |
13.4. | Inspect for fuel leaks. |