GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Important: Clean the area around the camshaft position (CMP) sensor before removal in order to prevent debris from entering the engine.

  1. Remove the engine cover. Refer to Engine Cover Replacement .

  2. Object Number: 260128  Size: SH
  3. Disconnect the CMP sensor electrical connector.
  4. Remove the CMP sensor bolt.
  5. Remove the CMP sensor.

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 260128  Size: SH
  1. Install the CMP sensor.
  2. Install the CMP sensor bolt.
  3. Tighten
    Tighten the bolt to 25 N·m (18 lb ft).

  4. Connect the CMP sensor electrical connector.
  5. Install the engine cover. Refer to Engine Cover Replacement .