GM Service Manual Online
For 1990-2009 cars only

Step

Action

Yes

No

Schematic Reference: Instrument Cluster Schematics

Connector End View References: Instrument Panel, Gages, and Console Connector End Views, Powertrain Control Module Connector End Views for the 4.3L engine, Powertrain Control Module Connector End Views for the 4.8L, 5.3L, and 6.0L engine or Engine Control Module Connector End Views for the 6.6L (LLY) engine

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

2

  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. With the scan tool, observe one of the engine oil life remaining parameters:
  4. • Engine Oil Life Remaining parameter in the powertrain control module (PCM) Engine Data 2 data list - gas only.
    • Engine Oil Life Remaining parameter in the PCM Engine Data 1 data list - 6.6L diesel only.

Does the Engine Oil Life parameter display 0%?

Go to Step 3

Go to Testing for Intermittent Conditions and Poor Connections

3

Replace the instrument panel cluster (IPC). Refer to Control Module References for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 4

--

4

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2