Caution: Do not attempt to move vehicle with drive axle(s) removed from wheel bearing. Wheel(s) could fall off, dropping vehicle to the ground and causing personal injury or damage to the vehicle.
J 45859 Axle Remover
Important: Before installing the front wheel drive shaft in the steering knuckle, ensure that the splines on the drive shaft are free and clear of rust or dirt.
3.1. | Remove all traces of the original adhesive patch. |
3.2. | Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry. |
3.3. | Apply Threadlocker, GM P/N 12345382 (Canadian P/N 10953489) to the threads of the bolt. |
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the wheel drive shaft retaining bolts to 79 N·m (58 lb ft).
Tighten
Tighten the wheel drive shaft retaining bolts to 79 N·m (58 lb ft).
Tighten
Tighten the wheel drive shaft retaining nuts to 210 N·m (155 lb ft).