For 1990-2009 cars only
Removal Procedure
- Remove the window regulator handle, if equipped. Refer to Door Window Regulator Handle Replacement .
- Remove the inside door handle bezel. Refer to Front Side Door Inside Handle Bezel Replacement .
- Remove the screws (2) that retain the front door trim plate (1) to the door panel.
- Pull the bottom of the front door trim plate (1) out in order to release the front door trim plate (1) retainers.
- Remove the front door trim plate from the front door trim panel.
- Disconnect the electrical connectors from the switches on the front door trim plate, if equipped.
- Remove the front door trim plate (1) from the vehicle.
Installation Procedure
- Partially install the front door trim plate (1) to the front door trim panel.
- Connect the electrical connectors to the switches, if equipped.
- Align the retainers on the front door trim plate (1) to the slots in the front door trim panel
- Push towards the door panel to engage the front door trim plate (1) retainers.
- Install the screws (2).
- Install the inside door handle bezel. Refer to Front Side Door Inside Handle Bezel Replacement .
- Install the window regulator handle, if equipped. Refer to Door Window Regulator Handle Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screw that retains the front door trim plate to 1.9 N·m
(17 lb in)
