Front Side Door Emblem/Nameplate Replacement Express Access
Tools Required
J 25070
Heat Gun
Removal Procedure
Important: Use the tape for protection and alignment marks for alignment of the new emblem.
- Apply tape to the area around the door emblem.
- Heat the emblem/nameplate, using a heat gun
J 25070
152 mm (6.0 in) from the surface.
- Apply the heat using a circular motion for about 30 seconds.
Notice: Use a plastic, flat-bladed tool to prevent paint damage when removing
an emblem/name plate.
- Remove the emblem/nameplate
from the door surface using a plastic, flat-bladed tool.
- Remove all adhesive from the door panel
surface and the back of the emblem/nameplate using 3M™ Scotch Brite Molding
Adhesive Remover Disk 3M™ P/N 07501 or equivalent.
- Clean the door surface using varnish makers and painters (VMP) naptha.
Installation Procedure
- If the location of the emblem/nameplate
has not been marked, apply tape.
- Warm the door surface with a heat gun
J 25070
152 mm (6.0 in) from the surface to a minimum of 21°C
(70°F).
Important: Do not touch the adhesive backing of the emblem/nameplate.
- Remove the backing from the front end of the emblem/nameplate.
- Press the emblem/nameplate to the door panel surface while continuing
to remove the backing.
- Hand roll the emblem/nameplate to the door panel to ensure proper adhesion.
- Inspect the emblem/nameplate for bonding.
- Remove the tape from the area around the door emblem.
Front Side Door Emblem/Nameplate Replacement Savana Pro
Tools Required
J 25070
Heat Gun
Removal Procedure
Important: Use the tape for protection and alignment marks for alignment of the new emblem.
- Apply tape to the area around the door emblem.
- Heat the emblem/nameplate, using a heat gun
J 25070
152 mm (6.0 in) from the surface.
- Apply the heat using a circular motion for about 30 seconds.
Notice: Use a plastic, flat-bladed tool to prevent paint damage when removing
an emblem/name plate.
- Remove the emblem/nameplate
from the door surface using a plastic, flat-bladed tool.
- Remove all adhesive from the door panel surface and the back of the emblem/nameplate
using 3M™ Scotch Brite Molding Adhesive Remover Disk 3M™ P/N 07501
or equivalent.
- Clean the door surface using varnish makers and painters (VMP) naptha.
Installation Procedure
- If the location of the emblem/nameplate has not been marked, apply tape.
- Warm the door surface with a heat gun
J 25070
152 mm (6.0 in) from the surface to a minimum of 21°C
(70°F).
Important: Do not touch the adhesive backing of the emblem/nameplate.
- Remove the backing from the front end of the emblem/nameplate.
- Press the emblem/nameplate to the door panel surface while continuing
to remove the backing.
- Hand roll the emblem/nameplate to the door panel to ensure proper adhesion.
- Inspect the emblem/nameplate for bonding.
- Remove the tape from the area around the door emblem.