GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 362106  Size: SH
  1. Remove the screws holding the retaining ring to the headlamp housing assembly.
  2. Remove the retaining ring from the position lamp.
  3. Remove the headlamp capsule (1) from the position lamp.
  4. Remove the bulb (4) and socket from the rubber grommet in the lamp capsule.
  5. Push in on the side of the bulb (4) and turn the bulb 1/4 turn counterclockwise.
  6. Remove the bulb (4) from the socket.

Installation Procedure


    Object Number: 362106  Size: SH
  1. Install the bulb (4) to the socket.
  2. Push in on the bulb (4) and turn 1/4 turn clockwise.
  3. Install the bulb (4) and socket into the rubber grommet in the headlamp capsule (1).
  4. Install the headlamp capsule (1) to the headlamp housing.
  5. Install the retaining ring to the headlamp housing assembly.
  6. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  7. Install the screws to the retaining ring to the headlamp housing assembly.
  8. Tighten
    Tighten the screws to 1.5 N·m (13 lb in).