Schematic Reference: Headlights/Daytime Running Lights (DRL) Schematics

Connector End View Reference: Lighting Systems Connector End Views

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

1. Place the headlamp switch in the HEAD position.
2. Place the dimmer switch in the low beam position.
3. Turn ON the flash to pass (FTP) switch.

Do the high beam headlamps illuminate momentarily?

Go to Testing for Intermittent Conditions and Poor Connections

Go to Step 3

1. Place the headlamp switch in the HEAD position.
2. Connect a fused jumper from ground to the headlamp switch flash to pass signal circuit terminal of the headlamp dimmer switch connector.

Do the high beam headlamps illuminate?

Go to Step 6

Go to Step 4

Test the headlamp switch flash to pass signal circuit for high resistance or an open. Refer to Circuit Testing and Wiring Repairs .

Did you find and correct the condition?

Go to Step 9

Go to Step 5

Inspect for poor connections at the harness connector of the body control module (BCM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 9

Go to Step 7

Inspect for poor connections at the harness connector of the dimmer switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 9

Go to Step 8

Replace the BCM. Refer to Control Module References for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 9

--

Replace the headlamp dimmer switch. Refer to Turn Signal Multifunction Switch Replacement .

Did you complete the repair?

Go to Step 9

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3