Removal Procedure
- Raise the seat to the full UP position, if equipped with power seats.
- Disconnect the electrical harness (6) from the power seat motors, if equipped.
- Remove the nuts (3) retaining the seat adjuster (2) to the seat riser (4).
- Remove the front seat and the seat adjuster from the seat riser.
- Remove the bolts retaining the seat adjuster to the seat cushion frame (1).
- Remove the seat adjuster (2) from the seat.
Installation Procedure
- Position the seat adjuster (2) to the seat cushion frame (1).
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the bolts to retain the seat adjuster (2) to the seat cushion frame (1).
Tighten
Tighten the bolts to 25 N·m (18 lb ft).
- Position the seat cushion (1) and the seat adjuster (2) to the seat riser (4).
- Install the nuts (3) to retain the seat adjuster to the seat riser.
Tighten
Tighten the nuts (3) to 45 N·m (33 lb ft).
- Connect the electrical connectors to the power seat motors, if equipped.