Removal Procedure
Caution: When carrying an undeployed inflatable restraint seat belt pretensioner:
• | Do not carry the seat belt pretensioner by the wires or connector. |
• | Carry the seat belt pretensioner by the piston tube, keeping hands and
fingers away from the cable. |
• | Make sure the open end of the seat belt pretensioner piston tube points
away from you and other people. |
• | Do not cover the seat belt pretensioner piston tube opening with your
hand. |
Failure to observe these guidelines may result in personal injury.
- Disable the SIR system. Refer to
SIR Disabling and Enabling or
SIR Disabling and Enabling.
- Lift the buckle cover.
- Remove the seat belt buckle pretensioner retaining bolt from the seat.
- Disconnect the electrical connector from the seat belt buckle pretensioner, if equipped.
- Remove the seat belt buckle pretensioner from the seat.
Installation Procedure
- Install the seat belt buckle pretensioner to the seat.
- Connect the electrical connector to the seat belt buckle pretensioner, if equipped.
- Lift the buckle cover.
Notice: Refer to Fastener Notice in the Preface section.
- Install the seat belt buckle pretensioner retaining bolt to the seat.
Tighten
Tighten the seat belt buckle pretensioner retaining bolt to 52 N·m (38 lb ft).
- Enable the SIR system. Refer to
SIR Disabling and Enabling or
SIR Disabling and Enabling.