Removal Procedure
- Disconnect the negative battery cable. Refer to
Battery Negative Cable Disconnection and Connection
.
- Press tabs (3) inward to lift and remove the junction block cover (1).
- Note location and remove harness end nuts (2) and remove harness ends from fuse block relay center.
- Remove the fuse block center bolts and remove fuse relay center from the junction block.
- Remove from the junction block base the chassis harness (1), the I/P harness (2), the engine harness (3),
and the forward LP harness (4).
- Remove the junction block base by pressing tabs (1) then slide tabs (2) out.
Installation Procedure
- Install the junction block base by sliding tabs (2) in and pressing in tabs (1) until they are locked.
- Install into the junction block base the chassis harness (1), the I/P harness (2), the engine harness (3),
and the forward LP harness (4).
- Install the fuse relay center into the junction block.
- Install the fuse block center bolts.
- Install the harness ends on the fuse block relay center.
- Install the harness end nuts (2).
- Install the junction block cover (1) the tabs (3) should lock.
- Connect the negative battery cable. Refer to
Battery Negative Cable Disconnection and Connection
.