Steering Gear Pitman Shaft Seal and Bearing Replacement - Off Vehicle 700 Gear

Tools Required

1. Remove the Pitman shaft and the side cover. Refer to Steering Gear Pitman Shaft and Housing Cover Replacement - Off Vehicle .
2. Remove the Pitman arm (3) from the steering gear (1).
3. Remove the Pitman shaft boot (2).



4. Remove the dust seal (1).
5. Remove the retaining ring using the J 4245 .




Important: Use care not to score the steering gear housing bore when prying out the seals and the washers.

6. Use a screwdriver to pry the backup washer (3) and the double lip seal (2) from the steering gear housing (1).
7. Inspect the steering gear housing (1) for burrs.



8. Insert J 6278 through the hole in the top of the steering gear housing (1).
9. Drive out the needle bearing (2).

1. Install the needle bearing (2) to the steering gear housing (1) using the J 6278 .



2. Coat the double lip seal (2) and the washer (3) with grease.
3. Install the double lip seal (2).
4. Install the backup washer (3).



5. Install the retaining ring using the J 4245 .

Important: Do not install the lock washer and nut until complete installation of the Pitman arm and its components have been installed. Do not adjust the Pitman shaft until all components have been installed on the steering gear housing.

6. Install the Pitman shaft and the side cover. Refer to Steering Gear Pitman Shaft and Housing Cover Replacement - Off Vehicle .
7. Install the dust seal (1).



8. Install the Pitman shaft boot (2).
9. Install the Pitman arm (3) to the steering gear (1).
10. Install the lock washer (4).

Notice: Refer to Fastener Notice in the Preface section.

11. Install the nut (5).

Tighten
Tighten the Pitman arm nut to 250 N·m (184 lb ft).

12. Refer to Steering Gear Pitman Shaft Over-Center Preload Adjustment - Off Vehicle to adjust the Pitman shaft.