Tools Required
J 42640
Steering Column
Anti-Rotation Pin
Removal Procedure
Notice: The wheels of the vehicle must be straight ahead and the steering column
in the LOCK position before disconnecting the steering column or intermediate
shaft from the steering gear. Failure to do so will cause the SIR coil assembly
to become uncentered, which may cause damage to the coil assembly.
- Install the
J 42640
in
the steering column lower access hole.
- Remove the intermediate shaft bearing. Refer to
Intermediate Steering Shaft Bearing Replacement
.
- Remove the upper intermediate shaft (2)
to steering column retaining nut and bolt (1).
- Disconnect the upper intermediate shaft from the steering column and remove
the upper intermediate shaft.
Installation Procedure
- Install the upper intermediate shaft and
connect the upper intermediate shaft to the steering column.
Notice: Refer to Fastener Notice in the Preface section.
- Install the upper intermediate shaft (2) to steering column retaining
nut and bolt (1).
Tighten
Tighten the nut to 62 N·m (46 lb ft).
- Install the intermediate shaft bearing. Refer to
Intermediate Steering Shaft Bearing Replacement
.
- Remove the
J 42640
from the steering column lower access hole.