Removal Procedure
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing
any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to
the vehicle or its components.
- Disconnect the battery negative cable. Refer to
Battery Negative Cable Disconnection and Connection
in Engine Electrical.
Caution: Refer to SIR Caution in the Preface section.
- Disable the SIR system. Refer to
SIR Disabling and Enabling
in SIR.
- Remove the steering column trim covers. Refer to
Steering Column Trim Covers Replacement
.
- Turn the ignition lock cylinder to the start position.
- Insert the tip of an awl into the access hole (1) of the ignition
lock cylinder.
- Push down and hold the retaining pin of the ignition lock cylinder.
- Release the ignition lock cylinder to the run position.
- Remove the ignition lock cylinder by pulling
the cylinder away from the steering column.
Installation Procedure
- Install the ignition lock cylinder by performing
the following procedure:
1.1. | Align the positioning locking tab slot on the lock module to the positioning
tab on the ignition lock cylinder. |
1.2. | Push the lock cylinder in until the tab locks in the lock module. |
- Install the steering column trim covers. Refer to
Steering Column Trim Covers Replacement
.
- Enable the SIR system. Refer to
SIR Disabling and Enabling
in SIR.
- Connect the battery negative cable. Refer to
Battery Negative Cable Disconnection and Connection
in Engine Electrical.
- Perform the Passlock learn procedure. Refer to
Programming Theft Deterrent System Components
in Theft Deterrent.