As the front wheels spin, each wheel speed sensor produces an AC signal. The electronic brake control module (EBCM) uses the frequency of the AC signals to calculate each wheel speed. The powertrain control module (PCM) converts the signal from the vehicle speed sensor (VSS) to a 128k pulses/mile signal. The EBCM uses the vehicle speed signal from the PCM to calculate the rear wheel speed.
This diagnostic procedure supports the following DTC:
DTC C0245 Wheel Speed Sensor Frequency Error
• | The ignition is ON. |
• | The vehicle speed is greater than 8 km/h (4 mph). |
• | No brake application or deceleration is detected. |
• | No wheel slip is detected. |
• | No turning maneuvers are detected. |
• | At least one wheel speed sensor signal is 15 percent less than or greater than, other wheel speed sensor signals. |
• | All of the conditions for running and setting the DTC are present for a cumulative time of 3 minutes during a single ignition cycle. |
• | The EBCM disables the ABS/dynamic rear proportion (DRP). |
• | The ABS indicator turns ON. |
• | The brake warning indicator turns ON. |
The Conditions for Setting the DTC are no longer present and you use the scan tool Clear DTCs function.
Installing one tire of significantly different size on the vehicle causes this DTC to set. Operating the vehicle with a tire that has very low air pressure may also set this DTC. Inspect the vehicle for an incorrect or damaged wheel speed sensor or VSS if the tires and the EBCM and PCM calibrations are OK.
The number below refers to the step number on the diagnostic table.
Step | Action | Yes | No |
---|---|---|---|
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 | Inspect both of the front tires on the vehicle to ensure that both tires are of equal size. Are both of the front tires of equal size? | Go to Step 3 | Go to Diagnostic Aids |
3 | Inspect both of the rear tires on the vehicle to ensure that both tires are of equal size. Are both of the rear tires of equal size? | Go to Step 4 | Go to Diagnostic Aids |
Verify the electronic brake control module (EBCM) and the powertrain control module (PCM) both have the correct tire size calibration. Use the scan tool in order to view the EBCM tire size calibration or perform the Tire Size Calibration procedure and refer to Control Module References . Did you find and correct the condition? | Go to Step 5 | Go to Diagnostic Aids | |
5 |
Does the DTC reset? | Go to Step 2 | System OK |