Removal Procedure
Caution: Refer to Brake Dust Caution in the Preface section.
Caution: Refer to Brake Fluid Irritant Caution in the Preface section.
- Inspect the fluid level in the brake master cylinder reservoir.
- If the brake fluid level is midway between the maximum-full point and the minimum allowable level, no brake fluid needs to be removed from the reservoir before proceeding.
- If the brake fluid level is higher than midway between the maximum-full point and the minimum allowable level, remove brake fluid to the midway point before proceeding.
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle.
- Remove the tire and wheel assembly. Refer to
Tire and Wheel Removal and Installation.
- Compress the brake caliper pistons.
• | Install a large C-clamp over the top of the caliper housing and against the back of the outboard pad. |
• | Slowly tighten the C-clamp until the pistons are pushed completely into the caliper bores. |
• | Remove the C-clamp from the caliper. |
- Clean all dirt and foreign material from the brake hose end.
Important: Install a rubber cap or plug to the exposed brake pipe fitting end to prevent brake fluid loss and contamination.
- Remove the brake hose to caliper bolt from the brake caliper.
- Remove and discard the 2 copper brake hose gaskets. These gaskets may be stuck to the brake caliper housing or the brake hose end.
- Remove the brake hose from the caliper.
- Remove the 2 brake caliper mounting bolts.
Caution: Do not depress the brake pedal with the brake rotors/calipers and/or
the brake drums removed. Damage to the brake system may result. If brake system
damage occurs and is not repaired, vehicle damage and/or personal injury or
death may result.
- Remove the brake caliper from the brake caliper mounting bracket.
Installation Procedure
- Install the brake caliper to the brake caliper mounting bracket.
- Perform the following procedure before installing the caliper mounting bolts.
2.1. | Remove all traces of the original adhesive patch. |
2.2. | Clean the threads of the bolt with brake parts cleaner or the equivalent and allow to dry. |
2.3. | Apply Threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolt. |
Notice: Refer to Fastener Notice in the Preface section.
- Install the 2 brake caliper mounting bolts.
Tighten
Tighten the bolts to 108 N·m (80 lb ft).
- Remove the rubber cap or plug from the exposed brake hose fitting end.
Important: Install 2 new copper brake hose gaskets.
- Assemble the 2 new copper brake hose gaskets and the brake hose to caliper bolt to the brake hose.
- Install the brake hose to caliper bolt to the brake caliper.
Tighten
Tighten the brake hose to caliper bolt to 44 N·m (32 lb ft).
- Bleed the hydraulic brake system. Refer to
Hydraulic Brake System Bleeding.
- Install the tire and wheel assembly. Refer to
Tire and Wheel Removal and Installation.
- Lower the vehicle.
- Fill the master cylinder reservoir to the proper level with clean brake fluid. Refer to
Master Cylinder Reservoir Filling.