Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the engine mount to frame mounting bolts.
- Use a jack on the square tab at the rear of the engine block, and raise the engine, left side shown.
- Remove the engine mount to engine mounting bolts.
- Remove the engine mount.
Notice: Refer to Engine Mounting Notice in the Preface section.
Notice: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or crankshaft balancer. Jacking against the oil pan may cause it to crack or break.
Important: Raise the engine only enough to permit removal of the engine mount.
Installation Procedure
- Install the engine mount to the vehicle.
- Install the engine mount to engine mounting bolts.
- Lower the engine.
- Install the engine mount to frame mounting bolts.
- Lower the vehicle.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the engine mount to engine bolts to 50 N·m (37 lb ft).
Tighten
Tighten the engine mount to frame bolts to 60 N·m (44 lb ft).
