Disassembly Procedure
- Remove the brake master cylinder from the
vehicle. Refer to
Master Cylinder Replacement
.
- Secure the mounting flange of the brake master cylinder in a bench vise
so that the rear of the primary piston is accessible.
- Clean the outside of the master cylinder reservoir on and around the
reservoir cap prior to removing the cap and diaphragm.
- Remove the reservoir cap and diaphragm from the reservoir.
- Inspect the reservoir cap and diaphragm for the following conditions.
If any of these conditions are present, replace the affected component(s).
- Remove the master cylinder reservoir from the master cylinder. Refer
to
Master Cylinder Reservoir Replacement
.
- Using a smooth, round-ended tool, depress the primary piston (2)
and remove the piston retainer.
- Remove the primary piston assembly from the cylinder bore.
- Plug the cylinder inlet ports and the rear outlet port. Apply low pressure,
non-lubricated, filtered air into the front outlet port, in order the remove the
secondary piston (1) with the primary (6) and secondary (5)
seals, and the return spring.
- Discard the primary piston assembly, the piston retainer, and the seals
and seal retainer from the secondary piston.
Assembly Procedure
Important: Do not use abrasives to clean the brake master cylinder bore.
- Clean the interior and exterior of the master cylinder, the secondary piston (1),
and the return spring in denatured alcohol, or equivalent.
- Inspect the master cylinder bore, inlet and outlet ports, the secondary
piston (1), and the return spring for cracks, scoring, pitting, and/or corrosion.
Replace the master cylinder if any of these conditions exist.
- Dry the master cylinder and the individual components with non-lubricated,
filtered air.
- Lubricate the master cylinder bore, the secondary piston (1),
the return spring, and all of the individual overhaul components with Delco Supreme 11®,
GM P/N 12377967 (Canadian P/N 992667) or equivalent
DOT-3 brake fluid from a clean, sealed brake fluid container.
- Assemble the lubricated, new primary seal (6) and retainer, and
new secondary seal (5) onto the secondary piston.
- Install the lubricated return spring and secondary piston assembly (1)
into the cylinder bore.
- Install the lubricated, new primary piston assembly (2) into
the cylinder bore.
- Using a smooth, round-ended tool, depress the primary piston (2)
and install the new piston retainer.
- Install the master cylinder reservoir to the master cylinder. Refer
to
Master Cylinder Reservoir Replacement
.
- Install the reservoir cap and diaphragm to the reservoir.
- Install the master cylinder to the vehicle. Refer to
Master Cylinder Replacement
.