GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2006 🢒 Savana - AWD 🢒 General Information 🢒 General Information 🢒 Parking Brake Rear Cable Replacement - Right Side

Removal Procedure
  1. Release the park brake.
  2. Disable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Disabling .
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

    4. Object Number: 913335 Size: SH
  4. Disconnect the cable from the equalizer.
  5. For cargo and passenger vehicles, remove the cable from the rear crossmember by depressing the locking tabs.
  6. For cutaway vehicles, remove the cable from the mounting bracket by depressing the locking tabs.
  7. Pass the cable through the cable guide.

    8. Object Number: 1198926 Size: SH
  8. Disconnect the rear axle vent hose clip from the cable (1500 Series).

    9. Object Number: 1199000 Size: SH
  9. Gently open the rear axle clip.

    10. Object Number: 1198996 Size: SH
  10. Remove the cable from the differential clip.

    11. Object Number: 1198971 Size: SH
  11. Remove the bolt retaining the cable to the lower shock mount.

    12. Object Number: 913334 Size: SH
  12. Perform the following procedure to remove the cable (2) from the backing plate (4).
    13. 12.1. Compress the spring (3) by pushing towards the lever (1).
    12.2. Depress the locking tabs.
    12.3. Pull the cable housing out of the backing plate (4).
    12.4. Remove the cable (2) through the slot in the backing plate.
  13. Remove the park brake cable (2) from the lever (1).
  14. Remove the cable from the vehicle.

Installation Procedure

    Object Number: 913334 Size: SH
  1. Install the cable to the vehicle.
  2. Install the park brake cable (2) to the lever (1).
  3. Perform the following procedure to install the cable (2) to the backing plate (4).
    4. 3.1. Compress the spring (3) by pushing toward the lever (1).
    3.2. Route the cable (2) through the slot in the backing plate.
    3.3. Push the cable housing into the backing plate (4) until the locking tabs snap into place.

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1198971 Size: SH
  4. Install the bolt retaining the cable to the lower shock mount.

    5. Tighten
    Tighten the bolt to 13 N·m (115 lb in).


    Object Number: 1199016 Size: SH
  5. Install the cable to the differential clip.

    6. Object Number: 1198926 Size: SH
  6. Connect the rear axle vent hose clip to the cable (1500 Series).
  7. Pass the cable through the cable guide.
  8. For cutaway vehicles, install the cable to the mounting bracket until the locking tabs snap into place.
  9. For cargo and passenger vehicles, install the cable to the rear crossmember until the locking tabs snap into place.

    10. Object Number: 913335 Size: SH
  10. Connect the cable to the equalizer.
  11. Remove the safety stands.
  12. Lower the vehicle.
  13. Enable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Enabling
  14. Adjust the park brake cable. Refer to Park Brake Adjustment .